Manley MIC EQ 500 Combo Bedienungshandbuch

MANLEYLABORATORIES, INC.OWNER'S MANUALMIC EQ 500 COMBOMANLEY LABORATORIES, INC.13880 MAGNOLIA AVE.CHINO, CA. 91710TEL: (909) 627-4256FAX: (909)

BASIC MAINTENANCECHANGING THE FUSEAs with most gear a fuse may need to be replaced. The symptom is "no power" and no LEDs lit even thoughyo

FRONT PANELA B C D EF G H I J K L

CHASSISGROUNDMIC PRE INMIC PRE OUTLINE INLINE OUTFUSE2 AMPSLO-BLOCIRCUIT100 / 120 / 240 VAC(AS INDICATED)50 / 60 HZ OPERATIONREPLACE WITH SAME TYPE A

OPERATIONAL NOTESSWITCHING ONThe power switch is located on the right hand corner of the front panel. Flip the switch up to turn on thepreamplifier

SPECIFICATIONSVacuum Tubes: 2X 5751, 1X 6414, 1X 7044Fuse Type 2 AMP SLO-BLOLamp type 1/4 X 1 1/4, 12 volt, .15 ampMIC PRE SECTIONGain 46 dB maximu

WARRANTYAll Manley Laboratories equipment is covered by a limited warranty against defects in materialsand workmanship for a period of 90 days from

WARRANTY REGISTRATIONWe ask that you please fill out this registration form and send the bottom half to:MANLEY LABORATORIESREGISTRATION DEPARTMENT1388

CONTENTSINTRODUCTION 3MAINS CONNECTIONS 4CONNECTING YOUR PREAMPLIFIER 5CONNECTION EXAMPLES 6HINTS 7EQ CURVES 8BASIC MAINTENANCE 9FIGURE 1 FRONT PANEL

INTRODUCTIONTHANK YOU!...for choosing the Manley Laboratories "MIC EQ 500 COMBO". Designed by David Manley, TheMIC EQ 500 COMBO uses the be

MAINS CONNECTIONSYour MIC EQ-500 COMBO has been factory set to the correct mains voltage for your country.The voltage setting is marked on the serial

CONNECTING YOUR PREAMPLIFIERSetting up your Mic EQ-500 COMBO is rather easy. 1. Please refer to page 12 for an illustration of the back of the preampl

page 6THIS PAGE FOR CONNECTION EXAMPLES

HINTS, notes, etcThe MIC EQ-500 COMBO preamp section and make-up gain stage use a similar circuit toseveral of our most expensive yet most popular cir

This page is reserved for freq resp curves

Try taking advantage of the separate MIC and LINE sections by feeding to tape with the MICPRE OUTPUT and returning the signal from tape to the LINE IN