Manley PURIST PREAMPLIFIER Bedienungsanleitung Seite 1

MANLEYLABORATORIES, INC.OWNER'S MANUALTHE PURISTPREAMPLIFIERMANLEY LABORATORIES, INC.13880 MAGNOLIA AVE.CHINO, CA. 91710TEL: (909) 627-4256FA

WARRANTYAll Manley Laboratories equipment is covered by a limited warranty against defects in materialsand workmanship for a period of 90 days from

WARRANTY REGISTRATIONWe ask that you please fill out this registration form and send the bottom half to:MANLEY LABORATORIESREGISTRATION DEPARTMENT1388

CONTENTSINTRODUCTION 3MAINS CONNECTIONS 4CONNECTING YOUR PREAMPLIFIER 5FIGURE 1 FRONT PANEL 6FIGURE 2 REAR PANEL 7OPERATIONAL NOTES 8SPECIFICATIONS 9

INTRODUCTIONTHANK YOU!...for choosing the Manley Laboratories "The Purist Preamplifier". Designed by David Manley, the PuristPreamplifier

MAINS CONNECTIONSYour preamplifier has been factory set to the correct mains voltage for your country. Thevoltage setting is marked on the serial bad

CONNECTING YOUR PREAMPLIFIERSetting up your preamplifier is rather easy. 1. Please refer to page 7 diagram 2 for an illustration of the back of the pr

FRONT PANELA SET GAIN Switch to select general gain of the preamp to personal preferences. Dueto a lack of current standards of power amp and preamp

REAR PANELA FUSE HOLDER Replace with 1A SLO-BLO fuse only.B IEC MAINS SOCKET Standard IEC mains socket (120/240 VAC as indicated)C OUTPUT (XLR) L

OPERATIONAL NOTESSWITCHING ONThe power switch is located on the right hand corner of the front panel. Flip the switch up toturn on the preamplifier

SPECIFICATIONSVacuum Tubes: 2 x 5751, 2 x 6414 (Mil Spec)Approved substitutions for 5751 12AX7A( or 6072 with less gain)Approved substitutions for 6